How to clean a dishwasher comes down to three jobs: wash the filter, wipe the door seal and tub, then run an empty cleaning cycle with vinegar, citric acid or a store-bought cleaner. How often depends on your brand. GE, for example, says to clean the filters on its newer models every other month.
Many guides give one vinegar routine for every machine, but the makers’ own help pages disagree on timing, vinegar amounts and scrubbing. This Sweetly Clean guide gives a routine that works on most machines and shows where GE, Bosch and Whirlpool differ, so you can follow the advice that fits yours.
Key Takeaways
- Brands disagree on filter cleaning: Whirlpool says once a month, GE says every other month and Bosch says every few months.
- GE warns that scouring pads or brushes can damage its Ultra Fine filter, while Bosch tells owners to use warm, soapy water and a scrub brush.
- Whirlpool warns that vinegar is an acid and that using it too often could damage your dishwasher, so it saves vinegar for deep cleans.
- Some dishwashers, including older GE models, have self-cleaning filtration with no filter to remove.
- A 2019 New Hampshire Department of Environmental Services fact sheet counts water at 150 mg/L (9 gpg) or more as hard, and hard water leaves a white mineral film.
Want the rest of your home cleaned while you handle the dishwasher? Sweetly Clean charges a flat price by the job, and you see it as soon as you book online.
How Often Should You Clean Your Dishwasher?
For most homes, a basic cleaning about monthly and a deep clean a few times a year keep a dishwasher fresh. Basic means checking the filter and wiping the seal. Deep means an empty cycle with vinegar, citric acid, or a cleaner. Your own brand’s schedule still comes first, so check it before you settle on a routine.
The dishwasher manufacturers don’t agree on the filter. Whirlpool’s general rule is to clean it once a month, especially with frequent use. GE says every other month for the filters on its newer models, or more often with heavy use, and Bosch says every few months.
That is a widespread range for the same part, so the brand on your door matters. If you run the machine every day, lean toward the shorter schedule, since GE and Whirlpool both tie cleaning to heavy use.
Your dishes also tell you when it’s time. GE says that if your dishes feel gritty or wash results drop, the filters need cleaning.
Step-by-Step Dishwasher Cleaning for Most Machines
To clean most dishwashers, empty the racks, wash the filter, clear the spray arms, wipe the door seal and tub, then run an empty hot wash with a cleaner. Most of the cleaning process is hands-off machine time, and the only tools you need are a sponge, a cloth, and a toothpick.
Step 1: Empty the Racks and Clear Food Scraps
Take out every dish, then slide out the lower rack and top rack so you can see the floor of the tub. Pick out food scraps, broken glass, and stray labels by hand before they reach the drain.
Step 2: Remove and Wash the Filter
The dishwasher filter catches food so it doesn’t spray back onto your dishes. On many machines, it sits in the floor of the tub under the lower spray arm and twists out. Consumer Reports says filters you clean by hand are common on newer machines, so this step matters most for owners of newer dishwashers.
If you have an older dishwasher, you may not find a filter at all. GE says older GE dishwashers and some current models have self-cleaning filtration, usually with nothing to remove. When in doubt, check the dishwasher manual before you pull on any parts.
The washing method depends on the brand. GE says to use warm, soapy water and a sponge on its Ultra Fine filter and warns that scouring pads or brushes can damage it. Bosch’s steps say to wash the filter with warm, soapy water and a scrub brush. GE does allow a soft brush or sponge on its Fine Filter to remove calcium deposits caused by hard water. Rinse the filter under warm water until no food residue remains, then lock it back in place.
Step 3: Clear the Spray Arms
The spray arms spin and shoot water jets through small holes to reach every rack. When those holes clog with food bits or mineral deposits, parts of each load stay dirty.
Spin each arm by hand, and use a toothpick to remove debris from any blocked holes. Many arms lift off for a rinse, and your manual shows how yours detach.
Step 4: Wipe the Door Seal, Door and Tub
The rubber seal around the door collects grime that the wash doesn’t reach. Consumer Reports advises using a rag on the seal between the dishwasher door and the tub, where residue and food particles collect. Whirlpool also says to clean the bottom front of the tub, where soils tend to build up, and to wipe every surface, door gaskets included.
Wipe the dishwasher door, its inner edges, and the control panel with a damp cloth. On stainless steel interiors, use a soft cloth or sponge, because GE cautions that abrasive scouring pads or harsh cleaners can mar a dishwasher’s interior finish.
That seal is worth the effort. In a 2011 study reported by Phys.org, 62% of dishwashers sampled from private homes had fungi on the rubber door seal, many of them black yeasts. Scientific American, covering the same study of 189 dishwashers, noted that no dishwasher-caused infections were reported in those homes.
Step 5: Run an Empty Hot Wash
Put the filter back, close the door, and run an empty wash on the highest temperature setting your model allows, using one of the methods below. If your model has a self-cleaning cycle, your manual explains when to use it instead. Whirlpool recommends a hot cycle with a dishwasher cleaner and no dishes, ideally once a month, to keep the machine fresh.
Vinegar, Citric Acid or a Store-Bought Cleaner: Which Should You Use?
All three can work on most machines. The real differences are how much to use, how often to use it, and whether your brand warns against one of them. Follow the manufacturer’s instructions for your model first, and use the details below when your manual doesn’t say. GE says a dishwasher interior cleans itself through normal use, and that soap buildup, the cloudy soap scum on the walls, can be removed with vinegar, citric acid, or a dishwasher cleaner.
The Vinegar Cycle
GE and Whirlpool describe the vinegar cycle in different ways. GE says to pour vinegar into the dishwasher just after the detergent cup opens, then let the wash cycle finish. Whirlpool says to set 2 cups (500 mL) of white vinegar in a glass or dishwasher-safe measuring cup on the bottom rack. Whirlpool keeps the vinegar contained in a cup, while GE adds it loose partway through the wash. Follow the version for your brand rather than mixing the two.
How often matters more than how much. GE presents its rinse as something to repeat only when needed. Whirlpool warns that vinegar is an acid and that using it too often could damage your dishwasher, so it saves vinegar for deep cleans.
The Citric Acid Wash
GE suggests citric acid for interior stains. Its method fills the detergent cup with citric acid crystals and runs a normal cycle. When that full cycle ends, run another one with dishwasher detergent. GE says citric acid can be used in both plastic and stainless steel tubs. Keep metal items out of the dishwasher during the wash so they don’t tarnish.
Store-Bought Cleaners
Store-bought cleaners come with their own schedules. Finish, a detergent maker, recommends Finish Dishwasher Cleaner once every 3 months on its UK site. Its instructions say to place the bottle upside down in the silverware basket or at the bottom of the rack, then run an empty dishwasher. Whirlpool sells its own Affresh brand of cleaner. Whatever product you buy, follow its label, since each one has its own steps.
Where the Brands Disagree
Filter and Vinegar Advice from GE, Bosch and Whirlpool Support Pages
| Question | GE | Bosch | Whirlpool |
|---|---|---|---|
| How often to clean the filter | every other month | every few months | once a month |
| Scrub the filter with a brush? | Not on the Ultra Fine filter; use a sponge | Yes, with warm, soapy water and a scrub brush | Not covered in the pages used here |
| How to add vinegar | Poured in after the detergent cup opens | Not covered in the pages used here | 2 cups (500 mL) in a cup on the lowest rack |
| How often to use vinegar | Repeat when needed | Not covered in the pages used here | Deep cleans only |
Read across any row and you’ll see that no single routine matches all three brands. That is why the manual for your exact model matters more than any one guide, this one included.
Why Does Hard Water Leave White Film in Your Dishwasher?
Hard water carries dissolved minerals, mostly calcium and magnesium, that dry into a chalky white film on glasses and inside the tub. Over time this mineral buildup can coat the filter and clog spray arm holes, so your dishwasher cleans less well and needs a deep clean more often.
A 2019 fact sheet from the New Hampshire Department of Environmental Services says that in most waters, hardness of 150 mg/L (9 gpg) and above counts as hard and generally causes scale on pipes and fixtures. A 2020 NHDES fact sheet advises against water softeners unless hardness is over 150 mg/L and causing aesthetic problems. Whirlpool, for its part, recommends a water softener when hardness is 15 grains or more.
If you don’t know how hard your tap water is, a water test will tell you. For film you can already see, use rinse aid so water sheets off dishes instead of drying in spots. Run a citric acid wash when white deposits build up, which can help cloudy wine glasses come out sparkling clean again.
Common Dishwasher Cleaning Mistakes to Avoid
The biggest mistakes are using vinegar too often, scrubbing a filter that can’t take it, and putting the wrong soap in the machine. Each one can damage parts or leave the dishwasher dirtier than when you started, so check this list before your next clean.
- Putting dish soap in the dispenser. Hand dish soap makes far more suds than a dishwasher can handle, and the foam can spill onto your floor. Use only detergent made for dishwashers.
- Running vinegar every week. Whirlpool’s warning about acid damage is the reason to keep vinegar for occasional deep cleans.
- Scrubbing with the wrong tools. Abrasive pads can mar the tub finish, and a brush can damage some fine-mesh filters, so match the tool to your brand.
- Ignoring the filter. A dirty dishwasher with a clogged filter sends grime back across your dishes on every load.
- Counting on the sanitize cycle to clean the machine. GE’s Sanitization cycle uses a high-temperature final rinse to reduce bacteria on dishes, and it makes the cycle longer. It targets your dishes, not the filter or seal.
Other Tips for a Fresh Dishwasher
- Scrape food into the trash before each dishwashing cycle so less of it reaches the filter.
- After a deep clean, leave the door open a crack so the tub can air dry.
- A minute of regular cleaning, like wiping the door edges after a messy load, makes the next deep clean faster.
- A clean filter and clear spray arms mean cleaner dishes and less rewashing by hand.
- Add a monthly filter check to your weekly cleaning schedule so it doesn’t slip.
- Find more kitchen shortcuts in Sweetly Clean’s list of 36 cleaning hacks.
- Moving soon? A wiped-out dishwasher belongs on your move-out cleaning checklist.
When to Hire a Professional Cleaner
Cleaning a dishwasher is a job most people can handle on their own. Hiring a professional makes sense when the dishwasher is one small chore on a long list, or when you’d rather spend your weekend on something else while someone cleans the rest of the house.
Sweetly Clean is a locally owned maid service based in Dover, NH, cleaning homes across the New Hampshire Seacoast and southern Maine since 2014. A standard cleaning covers the bedrooms, bathrooms, kitchen, dining room, living room, hallways, and entryways.
Extras include inside the oven, inside the refrigerator, window cleaning, and laundry where a washer and dryer are present. Cleaners bring their own supplies and equipment and are insured, bonded, background-checked, drug-screened, and interviewed in person. If you have product preferences, just let Sweetly Clean know.
Prices are flat by the job, not by the hour, and you see them when you book online. Recurring cleaning has no contract and saves 20% weekly, 15% biweekly or 10% monthly, and every visit carries a 100% happiness guarantee.
Sweetly Clean offers house cleaning in Dover, NH and home cleaning in Portsmouth, NH, along with Somersworth, Rochester, Rye and the rest of the Seacoast.
In Maine, see house cleaning services in southern Maine for South Berwick, Berwick and North Berwick. Keep the routine above going between visits, and a clean dishwasher will match the rest of your freshly cleaned kitchen.
Dishwasher Cleaning FAQ
How do I get rid of the smell in my dishwasher?
To eliminate odors, start with the filter, since trapped food there is a common source of sour smells. Then wipe the bottom of the tub and the rubber door seal, scrape plates before loading, and run an empty hot wash with a store-bought cleaner or a vinegar rinse. If unpleasant odors come back within days, check that the drain hose isn’t kinked and the kitchen drain isn’t backing up.
How do I clean the outside of a stainless steel dishwasher?
Wipe the fronts of stainless steel dishwashers with a microfiber cloth and a little mild, soapy water, moving with the grain of the metal. Dry the surface right away so water spots don’t form. Skip steel wool, abrasive pads and bleach sprays, which can scratch or dull the finish. Some panels have a protective coating, so read the care section of your manual before you try a stainless steel polish.
Why are my dishes still dirty after I cleaned the dishwasher?
Dirty dishes after a cleaning often point to loading or water, not grime. Make sure tall pans don’t block the spray arms or the detergent dispenser, and use fresh detergent, since it clumps and weakens once it gets damp. Run hot water at the kitchen sink before you start so the first fill isn’t cold. If a cloudy film remains, hard water is a likely cause.
Can I clean my dishwasher with vinegar and baking soda?
Yes, as long as you use them one at a time, because vinegar and baking soda cancel each other out when mixed. A common approach is a vinegar rinse first, then a sprinkle of baking soda on the tub floor followed by a short hot rinse to freshen it. Check your manual before you start, since Whirlpool advises saving vinegar for deep cleans instead of routine use.
Ready for a cleaner home on the Seacoast or in southern Maine? Book a standard, deep or recurring cleaning with Sweetly Clean online in a few minutes.